ADIN1200BCP32Z-R7

A low power, single-port, 10 Mbps and 100 Mbps Ethernet transceiver with low latency specifications designed for industrial Ethernet applications. This design integrates an energy efficient Ethernet (EEE) physical layer device (PHY) core with all associated common analog circuitry, input and output clock buffering, management interface and subsystem registers, and media access control (MAC) interface and control logic to manage the reset, clock control and pin configuration. Available in a 5 mm×5 mm, 32-lead lead frame chip scale package (LFCSP) and can operate with a single 3.3 V supply, assuming the use of a 3.3 V MAC interface supply. A separate VDDIO supply enables the management data input/output (MDIO) and MAC interface supply voltages to be configured independently of the other circuitry on the ADIN1200 allowing operation at 1.8 V, 2.5 V, or 3.3 V. At power-up, held in hardware reset until each of the supplies has crossed its minimum rising threshold value and the power is considered good. Brownout protection is provided by monitoring the supplies to detect if one or more of them drops below a minimum falling threshold and holding the device in hardware reset until the power supplies return and satisfy the power-on-reset (POR) circuit. The MII management interface (also referred to as MDIO interface) provides a 2-wire serial interface between a host processor or MAC and the ADIN1200, allowing access to control and status information in the PHY core management registers. The interface is compatible with both IEEE 802.3 Standard Clause 22 and Clause 45 management frame structures. Can support cable lengths up to 180 meters.

Applications

• Industrial automation
• Process control
• Factory automation
• Robotics and motion control
• Building automation
• Test and measurement
• Industrial internet of things (IoT)

Key features

• 10BASE-Te/100BASE-TX IEEE 802.3 compliant
• MII, RMII and RGMII MAC interfaces
• 100BASE-TX RGMII latency transmit: < 124 ns, receive < 250 ns
• 100BASE-TX MII latency transmit: < 52 ns, receive < 48 ns
• EMC test standards IEC 61000-4-5 surge (±4 kV) IEC 61000-4-4 electrical fast transient (EFT) (± kV) IEC 61000-4-6 conducted immunity (10 V) EN55032 radiated emissions (Class A) EN55032 conducted emissions (Class A)
• Unmanaged configuration using multilevel pin strapping
• EEE in accordance with IEEE 802.3az
• Start of packet detection for IEEE 1588 time stamp support
• Enhanced link detection
• Configurable LED
• Crystal oscillator/clock input: 25 MHz
• 25 MHz/125 MHz synchronous clock output
• Small package and wide temperature range 32-lead, 5 mm×5 mm LFCSP Specified for -40°C to +105°C and -40°C to +85°C ambient operation
• Low power consumption 139 mW for 100BASE-TX 3.3 V/2.5 V/1.8 V MAC interface VDDIO supply Single-supply operation with 3.3 V VDDIO Integrated power supply monitoring and POR