SN74ABT646APW

These devices consist of bus-transceiver circuits, D-type flip-flops, and control circuitry arranged for multiplexed transmission of data directly from the input bus or from the internal registers. Data on the A or B bus is clocked into the registers on the low-to-high transition of the appropriate clock (CLKAB or CLKBA) input. Output-enable (OE) and direction-control (DiR) inputs are provided to control the transceiver functions. In the transceiver mode, data present at the high-impedance port can be stored in either register or in both. The select-control (SAB and SBA) inputs can multiplex stored and real-time (transparent mode) data. The direction control (DiR) determines which bus receives data when OC is low. In the isolation mode (OE high), A data can be stored in one register and/or B data can be stored in the other register. When an output function is disabled, the input function still is enabled and can be used to store and transmit data. Only one of the two buses, A or B, can be driven at a time. These devices are fully specified for partial-power-down applications using Ioff. The Ioff circuitry disables the outputs, preventing damaging current backflow through the devices when they are powered down. To ensure the high-impedance state during power up or power down, OE should be tied to VCC through a pullup resistor; the minimum value of the resistor is determined by the current-sinking capability of the driver.

Applications

• Bus management scenarios supporting real-time inter-bus data transfer, data storage, and stored data transmission

Key features

• Typical vOLP (Output Ground Bounce) < 1V at Vcc = 5V, TA = 25°C
• High-Drive Outputs (-32-mA loH, 64-mA loL)
• Ioff Supports Partial-Power-Down Mode Operation