USB3343-CP

USB334x is a family of Hi-Speed USB 2.0 Transceivers that provide a physical layer (PHY) solution well - suited for portable electronic devices. Both commercial and industrial temperature applications are supported. Each model in the USB334x family may use a 60MHz reference clock or the model - number specific reference clock shown on the Product Identification System page. Several advanced features make the USB334x the transceiver of choice by reducing both eBOM part count and printed circuit board (PCB) area. Outstanding ESD robustness eliminates the need for external ESD protection devices in typical applications. The internal Over - Voltage Protection circuit (OVP) protects the USB334x from voltages up to 30V on the VBUS pin. By using a reference clock from the Link, the USB334x removes the cost of a dedicated crystal reference from the design. The USB334x includes integrated 3.3V and 1.8V regulators, making it possible to operate the device from a single power supply.

Applications

• Cell Phones
• PDAs
• MP3 Players
• GPS Personal Navigation
• Scanners
• External Hard Drives Digital Still and Video Cameras
• Portable Media Players
• Entertainment Devices
• Printers
• Set Top Boxes
• Video Record/Playback Systems
• IP and Video Phones
• Gaming Consoles

Key features

• USB - IF Battery Charging 1.2 Specification Compliant
• Link Power Management (LPM) Specification Compliant
• Integrated ESD protection circuits - Up to ±25kV IEC Air Discharge without external devices
• Over - Voltage Protection circuit (OVP) protects the VBUS pin from continuous DC voltages up to 30V
• Integrated USB Switch (USB3341, USB3346, and USB3347) - Allows single USB port of connection by providing switching function for: –Battery charging –Stereo and mono/mic audio –USB Full - Speed/Low - Speed data
• RapidCharge Anywhere Provides: - 3 - times the charging current through a USB port over traditional solutions - USB - IF Battery Charging 1.2 compliance to any portable device - Charging current up to 1.5Amps via compatible USB host or dedicated charger - Dedicated Charging Port (DCP), Charging (CDP) & Standard (SDP) Downstream Port support
• flexPWR Technology - Extremely low current design ideal for battery powered applications - “Sleep” mode tri - states all ULPI pins and places the part in a low current state - 1.8V to 3.3V IO Voltage (USB3343)
• Single Power Supply Operation - Integrated 1.8V regulator - Integrated 3.3V regulator –100mV dropout voltage
• PHYBoost - Programmable USB transceiver drive strength for recovering signal integrity
• VariSense - Programmable USB receiver sensitivity
• “Wrapper - less” design for optimal timing performance and design ease - Low Latency Hi - Speed Receiver (43 HiSpeed clocks Max) allows use of legacy UTMI Links with a ULPI bridge
• External Reference Clock operation available - ULPI Clock Input Mode (60 MHz sourced by Link) 0 to 3.6V input drive tolerant - Able to accept “noisy” clock sources as reference to internal, low - jitter PLL - Crystal support available (USB3343)
• Smart detection circuits allow identification of USB charger, headset, or data cable insertion
• Includes full support for the optional On - The - Go (OTG) protocol detailed in the On - The - Go Supplement Revision 2.0 specification
• Supports the OTG Host Negotiation Protocol (HNP) and Session Request Protocol (SRP)
• UART mode for non - USB serial data transfers
• Internal 5V cable short - circuit protection of ID, DP and DM lines to VBUS or ground
• Industrial Operating Temperature - 40°C to +85°C
• 24 pin, QFN RoHS Compliant package (4×4×0.90 mm height)