PGA870IRHDT

The PGA870 is a wideband programmable-gain amplifier (PGA) for high-speed signal chain and data acquisition systems. The PGA870 has been optimized to provide high bandwidth, low distortion, and low noise, making it ideally suited as a 14-bit analog-to-digital converter (ADC) driver for wireless base station signal chain applications. The wide gain range of -11.5 dB to +20 dB can be adjusted in 0.5-dB gain steps through a 6-bit control word applied to the parallel interface. The gain control interface may be configured as a level-triggered latch or an edge-triggered latch, or it may be placed in an unlatched (transparent) mode. In addition to the 6-bit gain control, the PGA870 contains a power-down pin (PD) that can be used to put the device into a low-current, power-down mode. In this mode, the quiescent current drops to 2 mA, but the gain control circuitry remains active, allowing the gain of the PGA870 to be set before device power-up. The PGA870 is offered in a QFN-28 PowerPAD package.

Applications

• Programmable Gain IF Amplifier:
• Differential signal chains
• Single-ended to differential conversion
• Fast Gain Control Loops for: Test/measurement Digital radio signal chains
• ADC Driver for Wireless Base Station Signal Chains: GSM, WCDMA, MC-GSM
• Radar/Ranging Systems

Key features

• Wideband ±5-V Operation: 650-MHz Bandwidth Low Impedance, Voltage Mode Output
• Wide Gain Range: -11.5 dB to +20 dB
• Precise 0.5-dB Gain Steps
• Step-to-Step Gain Error = ±0.03 dB
• HD₂: -93 dBc at 100 MHz
• HD₃: -88 dBc at 100 MHz
• IMD₃: -98 dBc at 100 MHz, -95 dBc at 200 MHz
• OIP3: +47 dBm at 100 MHz; Exceeds +45 dBm for Frequencies to 300 MHz
• Flexible Gain Control Interface: Supports latched and unlatched options Gain may be set in power-down state
• Fast setup and hold times: 2.5 ns
• Low Disable Current: 2 mA
• Pb-Free (RoHS-Compliant) and Green Package