ATTINY13A-MMU

The ATtiny13A is a low-power CMOS 8-bit microcontroller based on the AVR® enhanced RISC architecture. By executing powerful instructions in a single clock cycle, the ATtiny13A achieves throughputs approaching 1 MIPS per MHz allowing the system designer to optimize power consumption versus processing speed.

Key features

• High Performance, Low Power AVR* 8-Bit Microcontroller
• Advanced RISC Architecture
• 120 Powerful Instructions
• Most Single Clock Cycle Execution
• 32 x 8 General Purpose Working Registers
• Fully Static Operation
• Up to 20 MIPS Througput at 20 MHz
• High Endurance Non-volatile Memory segments
• 1K Bytes of In-System Self-programmable Flash program memory
• 64 Bytes EEPROM
• 64 Bytes Internal SRAM
• Write/Erase Cycles: 10,000 Flash/100,000 EEPROM
• Data retention: 20 Years at 85°C/100 Years at 25°C
• Programming Lock for Self-Programming Flash & EEPROM Data Security
• Peripheral Features
• One 8-bit Timer/Counter with Prescaler and Two PWM Channels
• 4-channel, 10-bit ADC with Internal Voltage Reference
• Programmable Watchdog Timer with Separate On-chip Oscillator
• On-chip Analog Comparator
• Special Microcontroller Features
• debugWIRE On-chip Debug System
• In-System Programmable via SPI Port
• External and Internal Interrupt Sources
• Low Power Idle, ADC Noise Reduction, and Power-down Modes
• Enhanced Power-on Reset Circuit
• Programmable Brown-out Detection Circuit with Software Disable Function
• Internal Calibrated Oscillator
• I/O and Packages
• 8-pin PDIP/SOIC/SOIJ: Six Programmable I/O Lines
• 10-pad VDFN: Six Programmable I/O Lines
• 20-pad WQFN: Six Programmable I/O Lines
• Operating Voltage: 1.8 – 5.5V
• Speed Grade:
• 0 – 4 MHz @ 1.8 – 5.5V
• 0 – 10 MHz @ 2.7 – 5.5V
• 0 – 20 MHz @ 4.5 – 5.5V
• Industrial Temperature Range
• Low Power Consumption
• Active Mode: 190 μA at 1.8 V and 1 MHz
• Idle Mode: 24 μA at 1.8 V and 1 MHz