dsPIC33EP128MC202-I/MM

Key features

• Code Efficient (C and Assembly) Architecture
• Two 40-Bit Wide Accumulators
• Single Cycle (MAC/MPY) with Dual Data Fetch
• Single-Cycle, Mixed-Sign MUL plus Hardware Divide
• 32-Bit Multiply Support
• 1.0% Internal Oscillator
• Programmable PLLs and Oscillator Clock Sources
• Fail-Safe Clock Monitor (FSCM)
• Independent Watchdog Timer (WDT)
• Fast Wake-up and Start-up
• Low-Power Management modes (Sleep, Idle, Doze)
• Integrated Power-on Reset and Brown-out Reset
• 0.6 mA/MHz Dynamic Current (typical)
• 30 μA IPD Current (typical)
• Up to Three PWM Pairs with Independent Timing
• Dead Time for Rising and Falling Edges
• 7.14 ns PWM Resolution
• Programmable Fault Inputs
• Flexible Trigger Configurations for ADC Conversions
• ADC module: Configurable as 10-bit, 1.1 Msps with four S&H or 12-bit, 500 ksps with one S&H
• Six analog inputs on 28-pin devices and up to 16 analog inputs on 64-pin devices
• Flexible and Independent ADC Trigger Sources
• Up to Three Op Amp/Comparators with Direct Connection to the ADC module
• Additional dedicated comparator
• Programmable references with 32 voltage points
• Charge Time Measurement Unit (CTMU): Supports capacitive touch sensing
• Provides high-resolution time measurement (1 ns)
• On-chip temperature measurement
• 12 General Purpose Timers: Five 16-bit and up to two 32-bit timers/counters
• Four Output Compare (OC) modules, configurable as timers/counters
• PTG module with two configurable timers/counters
• 32-bit Quadrature Encoder Interface (QEI) module, configurable as a timer/counter
• Four Input Capture (IC) modules
• Peripheral Pin Select (PPS) to allow Function Remap
• Peripheral Trigger Generator (PTG) for Scheduling Complex Sequences
• Two UART modules (17.5 Mbps)
• With support for LIN/J2602 protocols
• Two Four-Wire SPI modules (15 Mbps)
• ECAN module (1 Mbaud) CAN 2.0B Support
• Two I²C modules (up to 1 Mbaud) with SMBus Support
• PPS to allow Function Remap
• Programmable Cyclic Redundancy Check (CRC)
• 4-Channel DMA with User-Selectable Priority Arbitration
• Sink/Source 12 mA or 6 mA, Pin-Specific for Standard VOH/VOL, Up to 22 or 14 mA, respectively for Non-Standard VOH1
• 5V Tolerant Pins
• Peripheral Pin Select (PPS) to allow Digital Function Remapping
• Selectable Open-Drain, Pull-ups and Pull-Downs
• Up to 5 mA Overvoltage Clamp Current
• Change Notification Interrupts on All I/O Pins
• AEC-Q100 REVG (Grade 1, -40℃ to +125℃)
• AEC-Q100 REVG (Grade 0, -40℃ to +150℃)
• Class B Safety Library, IEC 60730
• In-Circuit and In-Application Programming
• Two Program and Two Complex Data Breakpoints
• IEEE 1149.2 Compatible (JTAG) Boundary Scan
• Trace and Run-Time Watch