MC9S08GT16ACFDE

Key features

• 40-MHz HCS08 CPU HC08 instruction set with added BGND instruction
• Support for up to 32 interrupt/reset sources
• FLASH read/program/erase down to 1.8 V
• Up to 16K FLASH; up to 2K RAM
• Three very low power stop modes
• Reduced power wait mode
• Very low power real time interrupt for use in run, wait, and stop
• Clock sources to internal hardware frequency locked-loop (FLL): internal, external, crystal, or resonator
• Internal clock with ±0.2% trimming resolution and ±0.5% deviation across voltage or across temperature
• Optional watchdog computer operating properly (COP) reset
• Low-voltage detection with reset or interrupt
• Illegal opcode detection with reset
• Illegal address detection with reset
• FLASH block protect and security
• ATD — 8-channel, 10-bit analog-to-digital converter
• SCI — Two serial communications interface modules
• SPI — Serial peripheral interface module
• IIC — Inter-integrated circuit bus module
• Timer — One 3-channel timer PWM module (TPM) plus one 2-channel TPM
• KBI — 8-pin keyboard interrupt module
• 8 high-current pins (20 mA each)
• Software selectable pullups on ports when used as input
• Internal pullup on RESET and IRQ pin to reduce customer system cost
• Up to 38 general-purpose input/output (I/O) pins, plus one output-only pin, depending on package selection
• Background debugging system
• Breakpoint capability to allow single breakpoint setting during in-circuit debugging (plus two more breakpoints in on-chip debug module)
• On-chip, in-circuit emulation (ICE) debug module with real-time bus capture. On-chip ICE debug module containing two comparators and nine trigger modes. Eight deep FIFO for storing change-of-flow addresses and event-only data.
• Single-wire background debug interface
• 48-pin QFN • 44-pin QFP 42-pin PSDIP 32-pin QFN