MSP430F5358IPZR

The TI MSP series of ultra-low-power microcontrollers comes in a wide variety. Each member device is equipped with different peripheral sets to meet the needs of various applications. This architecture, when used in conjunction with five low-power modes, is the optimal choice for extending battery life in portable measurement applications. The device features a powerful 16-bit RISC CPU, using 16-bit registers and a constant generator to achieve maximum coding efficiency. This digitally controlled oscillator (DCO) can wake up from a low-power mode to an active mode within 3 µs (typical). The configuration of MSP430F665x and MSP430F565x series microcontrollers includes four 16-bit timers, one high-performance 12-bit ADC, three USCI, one hardware multiplier, DMA, one RTC module with an alarm function, one comparator, USB 2.0, and up to 74 I/O pins. The configuration of MSP430F645x and MSP430F535x series microcontrollers features one integrated 3.3V LDO, four 16-bit timers, one high-performance 12-bit ADC, three USCI, one hardware multiplier, DMA, one RTC module with an alarm function, one comparator, and up to 74 I/O pins.

Applications

• Analog and digital sensor systems
• Digital motor control
• Remote control
• Thermostats
• Digital timers
• Handheld instruments

Key features

• Supply voltage range: 3.6V down to 1.8V
• Ultra-low power consumption
• Active Mode (AM): All system clocks active: 295µA/MHz at 8MHz, 3.0V, Flash program execution (typical)
• Standby Mode (LPM3): Watchdog and power monitor with crystal available, full RAM retention, fast wake-up: 2.0µA at 2.2V, 2.2µA at 3.0V (typical)
• Off, Real-Time Clock (RTC) Mode (LPM3.5): Off mode with active RTC using crystal: 1.1µA at 3.0V (typical)
• Off Mode (LPM4.5): 0.45µA at 3.0V (typical)
• Wake-up from standby mode within 3µs (typical)
• 16-bit RISC architecture, extended memory, system clock up to 20MHz
• Flexible power management system
• Fully integrated LDO with programmable regulated core supply voltage
• Supply voltage supervision, monitoring, and brownout protection
• Unified clock system
• FLL control loop for frequency stabilization
• Low-power low-frequency internal clock source (VLO)
• Low-frequency trimmed internal reference source (REFO)
• 32kHz crystal oscillator (XT1)
• High-frequency crystal oscillator up to 32MHz (XT2)
• Four 16-bit timers, each with 3, 5, or 7 capture/compare registers
• Three universal serial communication interfaces (USCI)
• USCI_A0, USCI_A1, and USCI_A2 each support: Enhanced UART with automatic baud-rate detection, IrDA encoder and decoder, synchronous SPI
• USCI_B0, USCI_B1, and USCI_B2 each support: I2C, synchronous SPI
• Full-speed USB
• Integrated USB PHY
• Integrated 3.3V and 1.8V USB power system
• Integrated USB PLL
• Eight input and eight output endpoints
• 12-bit ADC with internal shared reference, sample-and-hold, and auto-scan
• Two 12-bit DACs with synchronization capability
• Voltage comparator
• Integrated LCD driver with contrast control up to 160 segments
• Hardware multiplier supporting 32-bit operations
• Serial in-system programming, no external programming voltage required
• 6-channel internal DMA
• RTC module with supply voltage backup switchover