R7FA6M4AF2CBM#BC0

High-performance 200 MHz Arm Cortex-M33 core, up to 1 MB code flash memory with Dual-bank, background and SWAP operation, 8 KB Data flash memory, and 256 KB SRAM with Parity/ECC. High-integration with Ethernet MAC controller, USB 2.0 Full-Speed, SDHI, Quad and Octa SPI, and advanced analog. Integrated Secure Crypto Engine with cryptography accelerators, key management support, tamper detection and power analysis resistance in concert with Arm TrustZone for integrated secure element functionality.

Key features

• Armv8-M architecture with the main extension
• Maximum operating frequency: 200 MHz
• Arm Memory Protection Unit (Arm MPU) – Protected Memory System Architecture (PMSAv8) – Secure MPU (MPU_S): 8 regions – Non-secure MPU (MPU_NS): 8 regions
• SysTick timer – Embeds two Systick timers: Secure and Non-secure instance – Driven by LOCO or system clock
• CoreSight™ ETM-M33
• Up to 1-MB code flash memory
• 8-KB data flash memory (100,000 program/erase (P/E) cycles)
• 256-KB SRAM
• Serial Communications Interface (SCI)×10 – Asynchronous interfaces – 8-bit clock synchronous interface – Smart card interface – Simple IIC – Simple SPI – Manchester coding (SCI3, SCI4)
• I²C bus interface (IIC)×2
• Serial Peripheral Interface (SPI)×2
• Quad Serial Peripheral Interface (QSPI)
• Octa Serial Peripheral Interface (OSPI)
• USB 2.0 Full-Speed Module (USBFS)
• Control Area Network module (CAN)×2
• Ethernet MAC/DMA Controller (ETHERC/EDMAC)
• SD/MMC Host Interface (SDHI)
• Serial Sound Interface Enhanced (SSIE)
• 12-bit A/D Converter (ADC12)×2 – 5 Msps at interleaving
• 12-bit D/A Converter (DAC12) × 2
• Temperature Sensor (TSN)
• General PWM Timer 32-bit (GPT32)×4
• General PWM Timer 16-bit (GPTl6)×6
• Low Power Asynchronous General Purpose Timer (AGT)×6
• Low power modes
• Battery backup function (VBATT)
• Realtime Clock (RTC) with calendar and VBATT support
• Event Link Controller (ELC)
• Data Transfer Controller (DTC)
• DMA Controller (DMAC)×8
• Power-on reset
• Low Voltage Detection (LVD) with voltage settings
• Watchdog Timer (WDT)
• Independent Watchdog Timer (IWDT)
• Capacitive Touch Sensing Unit (CTSU)
• Main clock oscillator (MOSC) (8 to 24 MHz)
• Sub-clock oscillator (SOSC) 32.768 kHz
• High-speed on-chip oscillator (HOCO) (16/18/20 MHz)
• Middle-speed on-chip oscillator (MOCO) (8 MHz)
• Low-speed on-chip oscillator (LOCO) (32.768 kHz)
• IWDT-dedicated on-chip oscillator (15 kHz)
• Clock trim function for HOCO/MOCO/LOCO
• PLL/PLL2
• Clock out support
• 5-V tolerance, open drain, input pull-up, switchable driving ability
• VCC: 2.7 to 3.6 V
• Ta=-40℃ to +105℃