SST26VF080A-80E/SN

The Serial Quad 1/0TM (SQI™) family of Flash memory devices features a six-wire, 4-bit |!/○ interface that allows for low-power, high-performance operation in a low pin count package. SST26VF080A also supports full command-set compatibility to traditional Serial Peripheral Interface (SPI) protocol. System designs using SQI Flash devices occupy less board space and ultimately lower system costs. All members of the 26 Series, SQI family are manufactured with proprietary, high-performance CMOS SuperFlash technology. The split-gate cell design and thick-oxide tunneling injector attain better reliability and manufacturability compared with alternate approaches. SST26VF080A significantly improves performance and reliability, while lowering power consumption. These devices write (Program or Erase) with a single-power supply of 2.3V - 3.6V. The total energy consumed is a function of the applied voltage, current and time of application. Since for any given voltage range, the SuperFlash technology uses less current to program and has a shorter erase time, the total energy consumed during any erase or program operation is less than alternative Flash memory technologies.

Key features

• Single Voltage Read and Write Operations: - 2.7V - 3.6V or 2.3V - 3.6V
• Serial Interface Architecture: - Nibble-wide multiplexed I/O’s with SPI-like serial command structure: - Mode 0 and Mode 3 - x1/x2/x4 Serial Peripheral Interface (SPI) Protocol
• High-Speed Clock Frequency: - 2.7V - 3.6V: 104 MHz maximum (Industrial) - 2.3V - 3.6V: 80 MHz maximum (Industrial and Extended)
• Burst Modes: - Continuous linear burst - 8/16/32/64-byte linear burst with wrap-around
• Superior Reliability: - Endurance: 100,000 cycles (minimum) - Greater than 100 years data retention
• Low-Power Consumption: - Active Read current: 15 mA (typical @ 104 MHz) - Standby Current: 15 μA (typical)
• Fast Erase Time: - Sector/Block Erase: 20 ms (typical), 25 ms (maximum) - Chip Erase: 40 ms (typical), 50 ms (maximum)
• Page-Program: - 256 bytes per page in x1 or x4 mode
• End-of-Write Detection: - Software polling the BUSY bit in STATUS register
• Flexible Erase Capability: - Uniform 4-Kbyte sectors - Uniform 32-Kbyte overlay blocks - Uniform 64-Kbyte overlay blocks
• Write-Suspend: - Suspend program or erase operation to access another block/sector
• Software Reset (RST) mode
• Software Write Protection: - Write protection through Block Protection bits in STATUS register
• Security ID: - One-Time-Programmable (OTP) 2-Kbyte Secure ID: - 128-bit unique, factory preprogrammed identifier - User-programmable area
• Temperature Range: - Industrial: -40℃ to +85℃ - Extended: -40℃ to +125℃
• Automotive AEC-Q100 Qualified
• Packages Available: - 8-contact WDFN (6 mm x 5 mm) - 8-lead SOIC (3.90 mm)
• All Devices are RoHS Compliant