TPS546C20ARVFR

The TPS546C20A device is a non-isolated DC-DC converter in a 5mm×7mm package that complies with the PMBus 1.3 specification. It integrates FETs and can operate at high frequencies and output a current of 35A. Two TPS546C20A devices can be connected in parallel to generate a load current of up to 70A. Current sensing is achieved by sampling a small amount of power stage current and is independent of the device temperature. The integrated NexFET power stage and optimized driver provide high-frequency, low-loss switching capabilities, enabling ultra-high-density power supply solutions. The PMBus interface enables the AVS function through VOUT_COMMAND and supports flexible converter configuration and monitoring of key parameters (including output voltage, current, and internal chip temperature monitoring). The response to fault conditions can be set to restart, latch, or ignore, depending on the system requirements.

Applications

• Test and measurement instruments
• Ethernet switches, optical switches, routers, base stations
• Servers
• Enterprise-grade storage SSDs
• High-density power solutions

Key features

• PMBus 1.3-compliant converter: two 35A devices stackable for up to 70A with current sharing
• Input voltage range: 4.5V to 18V
• Output voltage range: 0.35V to 5.5V
• 5mm × 7mm LQFN package with single thermal pad
• Integrated 3.2mΩ and 1.4mΩ stacked NexFET power stage
• Reference voltage 350mV to 1650mV for adaptive voltage scaling (AVS) and PMBus adjustment
• 0.5% accuracy at voltages ≥600mV
• Lossless low-side MOSFET current sensing
• Voltage mode control with input feedforward
• Differential remote sensing
• Single start-up to pre-biased output
• Output voltage and output current reporting
• Internal die temperature monitoring
• 2 PMBus addresses (master device 36d / slave device 37d)
• Pin-configurable startup Vout and soft-start values
• PMBus interface programmable — VOUT_COMMAND and AVS VOUT slew rate
• Overcurrent protection with thermal compensation
• UVLO, soft-start, and soft-stop
• PGOOD, OV, UV, and OT fault response
• Power-on and power-off delay
• Thermal shutdown
• Pin-configurable switching frequency: 200kHz to 1MHz
• Synchronization to external clock or output clock frequency sync